Fits loosely when installed properly, but will remain in place when the lid is turned over. Install: Place steam release handle on steam release pipe and press down. Steam release handle must be installed before use, and cleaned frequently.
Remove: Pull steam release handle up and off steam release pipe. Install: Place anti-block shield over prongs and press down until it snaps into position.Īnti-block shield prevents food particles from coming up through the steam release pipe, assisting with pressure regulation. Remove: Grip lid and press firmly against side of anti-block shield (pressing towards side of lid and up) until it pops off the prongs underneath.Īnti-block shield must be installed before use and cleaned frequently. Do not attempt to remove the lid while the cooker is pressurized. Do not touch the float valve while the cooker is pressurized. While float valve is up, contents of cooker are pressurized. Attach silicone cap to bottom of float valve. Place one finger on the flat top of float valve. Install: Drop float valve into float valve hole on top of lid. The float valve and silicone cap must be installed before use to seal in pressurized steam. Do not discard float valve or silicone cap.
Detach silicone cap from bottom side of float valve. Remove: Place one finger on the flat top of float valve. Refer to “Venting Methods” section in this Guide for information on releasing pressure. It pops up to indicate when the cooker is pressurized, and lowers into the lid when the cooker is depressurized. If puckering occurs, replace sealing ring. Do not use a stretched or damaged sealing ring. Failure to follow these instructions may cause food to discharge, which may lead to personal injury or property damage. Only use authorized Instant Pot® sealing rings. Replace your sealing ring every 12-18 months or when deformation or damage is noticed.Īlways check for cuts or deformations in sealing ring prior to cooking. The sealing ring is an integral part of product safety. Ensure entire sealing ring is snug behind sealing ring rack.Īfter closing the lid, the sealing ring creates an airtight seal between lid and cooker base. Install: Place sealing ring over sealing ring rack and press into place. Sealing ring must be installed before use. It should be centered in the lid and an even height all the way around. Remove: Pull sealing ring out from behind sealing ring rack. Lower lid into track, then turn lid clockwise until symbol on the lid lines up *Note: Always check lid for damage prior to cooking.Ĭlose: Grip handle and align the symbol on lid with on rim of cooker base. Open: Grip handle and turn lid counter-clock-wise until symbol on lid is aligned with symbol on rim of cooker base. When cooker is plugged in, it will play a jingle when the lid is opened and closed. Do not place appliance on or in close proximity to a hot gas or electric burner, or a heated oven heat from an external source will damage appliance.
Instant pot duo serial number#